|
|||||||||
|
|||||||||
| |||||||||
|
|||||||||
|
|||||||||
| |||||||||
|
|
|
| |||||||||
 |
|
|
«
Previous Thread
|
Next Thread
»
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
Dev Shed Forums Sponsor:
|
|
|
|
#1
September 10th, 2004, 04:11 PM
|
|||
|
|||
|
coonecting wireless router to router within network
I have just purchased a NETGEAR wireless router to add to an existing setup with and Origo router with USB print server built in. I need to keep the print server facility but also need wireless for two laptops. I have proceeded as far as I can with disabling DHCP on the NETGEAR with no success. At present I have swapped over routers, the NETGEAR is now the primary router with DHCP and the Origo with print server is connected to a LAN port on the NETGEAR, I do not seem to be able to connect to any printers or access the ORIGOs internal settings via a browser.
|
|
#2
September 10th, 2004, 06:48 PM
|
|||
|
|||
|
Shame you just didn't get a netgear fm114P which is a wireless router with builtin printserver or just a wireless access point.
but with that said I will bet you are connecting your Orego routers wan port to the netgears switch port. Instead us a crossover from the netgear switch port to the orego's switch port. this will turn the orego into a glorifed switch but dhcp traffic should go thru now.
|
|
| Viewing: Dev Shed Forums > System Administration > Networking Help > coonecting wireless router to router within network |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
 |
|
|
Del.icio.us
Digg
Google
Spurl
Blink
Furl
Simpy
Y! MyWeb
Linear Mode
