I am starting to write a assembly program for a mc68hc12. I will be reading a 8 bit signed number into PortA and outputting the results to 7 segment LED's, common anode. I will be using Port P to ouput the segments and PortCan to control the LED's displayed. I assume I need 4 LED's, 1 for the sign and 3 LEDs for the max number of 128. If I hard wired the data in I get something like below. How would I go about pulling the data in from a port and then displaying the number on a set of LED's?

Code:
org $1000
        ldaa #$ff
        staa DDRP
        ldaa #$7c
        staa DDRCAN
forever ldy #display
next    ldaa 0,y
        staa PORTP
        ldaa PROTCAN
        anda #$83
        staa PROTCAN
        ldaa 1,y
        oraa PORTCAN
        staa PORTCAN

;a delay subroutine here to would cycle back to forever

display
       fcc  $30,$40
       fcc  $6d,$20
       fcc  $79,$10
       fcc  $33,$08
       fcc  $5b,$04
Thanks