w2k to XP upgrade problem: HD driver migration issue

I am trying to upgrade from w2k to XP Pro, and get the
following message during "Preparing installation."

Your computer has a mass storage device that is not
supported on Windows XP. Setup was unable to migrate the
driver for this device. You will need to provide the
Manufacturer-supplied suppoet disk for this device during
the next phase of setup.

I click OK, it report minor other compatibility issues and
then I get the message,

Cannot Complete the Windows XP Setup Wizard

I have two drives. A new Maxtor Ultra ATA 120 and a Maxtor
40. I have the latest drivers, as far as I know and found
no information at Maxtor about this issue.

The Wizard suggested that I would need the install disk
for the new Maxtor 120, but I never got a chance to use
it, or was it requested.

Any suggestions would be appreciated.

Eric

as soon as the installation begins at the bottom of the screen it will say press F6 to load the drivers for your controller card. After a minute or so it will tell you it cant find any drivers press S-specify add drivers. then put your disk in and press enter after selecting your driver file.

make sure your hard drives jumper settings are correct, master slave, cable select, i use master on the primary and slave on the secondary